- Featured in:
Find out what is the best resume for you in our Ultimate Resume Format Guide.
Additional Energy Resume Samples
Wind Technician Resume Samples
No results found
0-5 years of experience
- Field service turbine repair; repairing components, improper wiring, etc
- Utilized torqueing, bold tension equipment, and basic hand tools
- Performed greasing; ensured shaft alignment is correct
- Climb ladders up to 300+ feet inside of tower
0-5 years of experience
- Perform gearbox and generator change out; oil exchange services on various wind turbine platforms.
- Utilize proper safety gear & protective equipment to ensure work is performed in a safe manner.
- Perform scheduled inspections, maintenance, troubleshooting and repairs, and replacements on various wind turbine equipment.
0-5 years of experience
- Supervised/ preformed appropriate torqueing on the flanges, tensioning blades, blade bearings, and base bolts. Applying the proper amount of newton meter on the yaw motors, anchors, and high speed coupler.
- Preformed preventive maintenance greasing the Yaw Claws, greasing the Main Shaft, and greasing the gear box.
- Preformed bearing repairs and blade repairs.
- Preformed tag lining during craning services to remove both blades and blade bearing from the tower and installing blades and blade bearing.
- Responsible for the safety of myself and all member of the team will always stop work if I see a unsafe act.
0-5 years of experience
- North American Major Component Change out Specialist and lead crane signalman
- Annual and semi-annual maintenance on Repower 2.165 Mw wind towers
- Lead trouble-shooter for 2.165 Mw generators, gearboxes and pitch systems
- Head of facility and vehicle maintenance
- Tower Rescue and Forklift Trainer
0-5 years of experience
- Quality inspections
- Repair gearbox coolers
- Maintained data logs on work performed
- Maintenance on wind energy gearbox parts
- Assist with disassembley and assembly on gearboxes
0-5 years of experience
- Perform service tasks as per the checklist given for that year.
- Install retrofits as they are presented to the site.
- Communicate with site leads about problems with turbines that are outside the normal scope of work.
- Assist team lead with inspections of truck, safety equipment, and tools for daily work.
- Keep up with approved LOTO procedures and assist team lead with the lock out of energy sources before performing duties.
- Inspect personal PFPE devices to make sure they are safe to use in the climbing of tower and occasions where there is a fall hazard during daily tasks.
- Inspect towers for problems with safety equipment, such as tie off points, glide lock rails, rescue devices, and escape hatches.
- Assist team lead to make sure paper work for service is filled out completely and correctly.
- Assist site with problems that arise from out of the ordinary circumstances, such as temperature issues, part replacement and programming issues with the turbines.
0-5 years of experience
- GE wind turbine site specialist
- Mechanical & Electrical fault diagnosis & repairs
- SCADA & PLC programming and troubleshooting
0-5 years of experience
Maintenance and troubleshooting of wind turbines
- Electric Operator 1, high voltage
- Site EHS
- Certified procedure writer
0-5 years of experience
- Troubleshooting
- Tower repair electrical and mechanical
- Tower and Vehicle Maintenance
- Climb 300′ 1-5 times daily
- Daily safety reports
- Checking parts in and out
- Inventory
- Job Hazard Analysis
0-5 years of experience
- Field Coordination
- Lead team in commissioning of blade repairs
- Service and Logistics
- Field operations and coordination
- Team set up and organization
- Inspections
- Documentation
- Quality
- Training